RoadRadar

Two-gate speed timer using your iPhone camera.
Tap Start, then Gates to place lines A and B on two landmarks a known distance apart.
--km/h
 
OFF



Gate setup
Drag the round A and B handles so each line runs across the lane, on the road surface, at two landmarks a measured distance apart. Drag the middle of a line to move it whole. Lines can be slanted, so this works side-on or angled down the road. The bar above each line shows live motion.
Zoom 1.0×

Settings

Site

Camera

What gets saved

Detection

Cloud backup

Storage

…

How it works

RoadRadar is a two-gate timer. It times a vehicle between gate A and gate B and works out speed = distance ÷ time.

Categories: OK at or under the limit · TOL within tolerance · OVER speeding · EXCESS excessive. "Speeders" means OVER and EXCESS.

Sessions: a session starts when you first Arm and runs until you tap End session in the Log. Each session gets its own stats and its own CSV export.

Accuracy: at 30 fps over 20 m, expect about ±2 to 3 km/h at 60 km/h. A longer gate distance is more accurate. Check your setup with a drive-through at a known speed.

Readings are estimates only. They are not calibrated or certified, so they aren't legal proof of speeding.

Sessions

To read a plate: drag a box around it, then tap Read plate in box.
No photo for this reading (data only).